Skip to main content

Electronics Projects

Search This Blog

USB Volume and Mute Controller

on May 05, 2012

Get link
Facebook
X
Pinterest
Email
Other Apps

I wrote an article for Nuts and Volts magazine that describes a USB volume and mute controller.

Get link
Facebook
X
Pinterest
Email
Other Apps

Popular Posts

Making PCBs using the toner transfer process

I make my own printed circuit boards (PCBs) using Press-n-Peel toner transfer sheets from http://www.techniks.com/ The process is repeatable, and produces excellent quality boards suitable for prototypes. With my HP Laserjet printer, I can reliably produce boards with track widths down to 10 mil. The PnP material requires only modest heat to transfer the toner (the "silk" setting on the iron), light pressure and about 2min. for a 2" x 3" board. In addition, the PnP material uses the normal laser printer settings, there is no advantage to setting the printer toner setting to "dark". Once the board has been etched and drilled, I tin plate the board using a tin plating solution available from MG Chemicals. Here is an example board for a 32 pin TQFP package (the AT90USB162): Here is another board that contains a CP2103 USB to RS232 bridge chip from Silicon Labs. This is a 28 pin QFN package (5mm x 5mm with 0.5mm pitch pins): This set of bo...

Vacuum Tube Headphone Amplifier

When I got interested in electronics, vacuum tubes were on the way out and were rapidly being replaced with transistors. I didn't build anything with tubes because transistors were the items that interested me. However, I've always been curious about tubes and recently a friend an I thought it would be fun to make a tube headphone amp. This project was first simulated using LTSpice IV, a free download from Linear Technologies with the addition of tube models also available online. The SPICE simulation shows a THD of less than 0.12% for a bandwidth of 10Hz to 100KHz and an overall gain of 12dB. I used a piece of aluminum extrusion that I obtained from a local metal shop for the chassis and milled it to fit the amplifier and power supply boards. The finish is Hammertone to give it the retro look. Here is a picture of the amplifier board and the high voltage/filament power supply (the high voltage toroid transformer is not shown). The input stage for each channel is an 1...

RCA 85-TA Restore

This project was a labour of love as they say. In the picture is an RCA 85TA 5-tube table radio manufactured around 1938. My grandfather bought it new. The radio sat on my grandparent's kitchen counter for as long as I can remember and then the radio eventually ended up in my hands. The cabinet finish required a complete restore and the radio emitted a loud hum when I switched it on - loud enough that I switched it off right away. A sure sign that the electrolytics in the power supply had dried out. Fortunately the tubes all checked out OK and all the mechanical parts were fine. I obtained a schematic for the radio and set to work. Once the chassis was opened up, inside looked more like a kind of electronic stew - a jumble of brown, waxy tubular capacitors and resistors connected point to point with every connection firmly attached before being hand soldered. Not as neat and tidy as modern PCB construction but still very functional. I replaced the wiring as most of it ...

Powered by Blogger